Last Updated 19th April 2006

This page provides a summary of how best to use the mount cutter that I recommend. This mount cutter is a Jakar mount cutter and can be purchased through this website. Please follow the link Tools For Sale for further details.

USEFUL TIPS FOR MOUNT CUTTING

(1) Make sure that the mount cutter runs up and down the straight edge groove smoothly.

(2) Check that the blade is sharp.

(3) Always mark out and cut the mounts from the back of the mountboard.

(4) Think about it three times, measure it twice and cut it once.

(5) Ensure that the bevel is going to be the right way.

(6) Cut the mount on the top of a scrap mountboard or cutting mat.

(7) Mind your fingers !

(8) Always use a razor blade to finish any under cutting that may be needed.

(9) Mind your fingers !

(10) Never push the middle of the mount out because it will tear the board.

(11) If at first, you don’t succeed ....................!

USEFUL TIPS FOR MULTI APERTURE MOUNTS

(1) Always draw a rough sketch with all dimensions shown

(2) If you make the border between the apertures smaller that the outside borders,this will look easier on the eye.

(3) Measure these points carefully and check your addition to avoid mistakes

(4) Draw the mount on the back of the board as usual

(5) Circle the points of intersection on the mounts, with a pencil, to make the shape clearer from the other lines.

(6) Make sure you have the mount cutter pointing the right way before cutting each line.

(7) Cut one hole at a time and remove the middle with a razor blade.

(8) For single mounts with one aperture, always have a greater width of mount at the base.

A Multi Aperature Mount